However, there is no guarantee that interference will not occur in a particular installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Should I not have it connected? I saw this thread say something about moving it further away, but that's never been an issue for me.Related manual: ScreenLogic® Interface User’s Guide (P/N 520493)įCC Regulatory Safety Notice – This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. The PA is connected directly to my Netgear C7000 modem-router with CAT5, and I see it appearing as an allowed device, but that's as far as I got. Does anyone know how to get the firmware installed onto the Windows laptop I'm borrowing - how can I figure out the subnet I need and where to change that? I haven't come across a thread here yet, but please correct me if I'm missing it. (At least the pool system ran this morning on schedule). Last night it would connect and show no readings of the pool temp or even start the pump. Did that, and now I lost all connectivity to the app on my phone.

Pentair didn't want to help with the connectivity issue whatsoever.Īfter looking through forums here, it seemed like the best solution was to hit the reset button 3 times. I have one right now, and called Pentair - they told me to first download the firmware, but when I went to install, nothing was appearing in the window (it said something about not being on the same subnet mask). I did change modems, but I think the remote issue was there before that.Ĭalled Pentair, and they told me that my PA firmware is way outdated, but I only have a Mac, and with the pandemic, it's been hard to get my hands on a Windows laptop.

I inherited the pool system, and it was working fine for a while, but noticed at some point that I couldn't connect remotely. Here's the longer version for more details: When How exactly do I go through the IP ranges on the router admin page? I'll share more below, but in short, I've got a Netgear C7000. Hi! The tl dr is that I'm running into the same issue.

Pentair screenlogic software download